Fluid-components-international 8-66B_12-64B Series Manual Guide User Manual download pdf

12-64B, 8-66B Installation, Operation and

Troubleshooting Guide

Document 06EN003322 Rev. -

Step 1. Pre-Installation

A. To get the best results, the sensor should be mounted 20 pipe diameters downstream from any flow disturbance

(valve, pipe elbow) and 10 pipe diameters upstream from any disturbance.

24 Hour Factory Service Hot Line: 1 (800) 854-1993

B. Verify the serial numbers on the enclosures, flow element and electronics (control circuit) match. The instrument

may not work if the serial numbers do not match.

Tag Location

On the top side of the local enclosure

The instrument tag shows the model number, tag number (if

noted on the order) and serial number along with other

important safety information. Compare this information with the

appropriate pipe installation drawings to be sure the instrument

is the correct configuration. Match the tag serial number on the

enclosure, flow element and control circuit.

Electronics Serial Number

Step 2. Flow Element Installation

Alert: DO NOT change the orientation of the flow element in the enclosure as the interconnecting RTD and

heater wiring could be stressed and damaged. DO NOT apply any torque to the flow element

enclosure - only apply to the pipe surface itself.

Install the flow element, with the Flat Up and Level (shown above) or parallel to the flow media (±2°) for top mounted

instruments. The enclosure, flow element and electronic control circuit card serial numbers should all match.

Flow Element Serial Number.

Also Showing Sensor Orientation Flat.

(Located near the enclosure.

It is also on the enclosure tag.)

C. Recommended installation/troubleshooting tools are a 1-3/8 inch open ended wrench to fit the NPT connection, a

small flat blade screw driver for manipulating potentiometers, a medium flat blade screwdriver for tightening

connections, 3 mm allen wrench for CENELEC approved instruments, and a DVM for Ohm/Voltage

measurements.

1 2 3 4

Summary of Contents

Page 1 - Troubleshooting Guide

12-64B, 8-66B Installation, Operation andTroubleshooting GuideDocument 06EN003322 Rev. -Step 1. Pre-InstallationA. To get the best results, the sensor

Page 2 - Step 3. Wiring Preparation

Model 12-64/8-66 2 Doc. No. 06EN003322 Rev.-12-64 Flow Switch and 8-66 Level Switch Installation and Outline DrawingStep 3. Wiring PreparationBefo

Page 3 - Step 5. Operation

Doc. No. 06EN003322 Rev. -3 Model 12-64/8-66INSTALLATION, OPERATION AND TROUBLESHOOTING GUIDE FLUID COMPONENTS INTLFCI recommends routing conduit to t

Page 4 - Step 6. Troubleshooting

Model 12-64/8-66 4 Doc. No. 06EN003322 Rev.-Adjustment With The Sensing Element Wet1. Determine that the sensing element is wet.2. Apply power to t

Comments to this Manuals

No comments

Fluid-components-international 8-66B_12-64B Series Manual Guide User Manual

Browse online or download User Manual for Equipment Fluid-components-international 8-66B_12-64B Series Manual Guide. Fluid Components International 8-66B_12-64B Series Manual Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Fluid-components-international 8-66B_12-64B Series Manual Guide